FRONT OIL SEAL : Removal and Installation
REMOVAL
1. Remove the following parts.
2. Remove front oil seal with a suitable tool.
CAUTION:
Be careful not to damage front cover and crankshaft.
INSTALLATION
(A) : Dust seal lip
(B) : Oil seal lip
: Engine outside
: Engine inside

CAUTION:
3. Installation of the remaining components is in the reverse order of removal.
Valve oil sealVALVE OIL SEAL : Removal and Installation REMOVAL Remove camshafts. Remove valve lifters. Rotate crankshaft, and set piston with valve oil seal to be removed to TDC. This will prevent ...

REAR OIL SEAL : Removal and Installation REMOVAL Remove transaxle assembly. Remove clutch cover and clutch disk (M/T models). Remove flywheel (M/T models) or drive plate (A/T or CVT model ...
Steering wheel
Tilt operation
Push the lock lever 1 down and adjust the
steering wheel up or down 2 to the desired
position.
Pull the lock lever 1 up to lock the steering
wheel in place.
WARNING
Do not adjust the steering wheel while
driving. You could lose control of your
vehicle and cause an accid ...
Output speed sensor
Exploded View
1. Transaxle assembly 2. Output speed sensor 3. O-ring
Front Genuine
NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
Disconnect the harness connector from output speed sensor.
NOTE:
Lift up the vehicle and perform the work from rear of the transaxle
asse ...