Nissan Versa (N17): IGN OFF Interlock door unlock function does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / IGN OFF Interlock door unlock function does not operate

Diagnosis Procedure

1.CHECK AUTOMATIC LOCK/UNLOCK SELECT SETTING IN WORK SUPPORT

  1. Select DOOR LOCK of BCM using CONSULT.
  2. Select AUTOMATIC LOCK/UNLOCK SELECT in WORK SUPPORT mode.
  3. Check AUTOMATIC LOCK/UNLOCK SELECT setting in WORK SUPPORT.

    Refer to BCS "DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)".

Is the inspection result normal?

YES >> GO TO 2.

NO >> Set Unlock Only or Lock/Unlock in AUTOMATIC LOCK/UNLOCK SELECT.

2.CHECK AUTOMATIC DOOR UNLOCK SELECT SETTING IN WORK SUPPORT

  1. Select DOOR LOCK of BCM using CONSULT.
  2. Select AUTOMATIC DOOR UNLOCK SELECT in WORK SUPPORT mode.
  3. Check AUTOMATIC DOOR UNLOCK SELECT setting in WORK SUPPORT.

    Refer to BCS "DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Set MODE 1 or MODE 3 in AUTOMATIC DOOR UNLOCK SELECT.

3.REPLACE BCM

  1. Replace BCM. Refer to BCS "Removal and Installation".
  2. Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Vehicle speed sensing auto lock operation does not operate

Diagnosis Procedure 1.CHECK AUTOMATIC LOCK/UNLOCK SELECT SETTING IN WORK SUPPORT Select DOOR LOCK of BCM using CONSULT. Select AUTOMATIC LOCK/UNLOCK SELECT in WORK SUPPORT mode. Check AUTOMAT ...

Hazard and buzzer reminder does not operate

Diagnosis Procedure 1.CHECK HAZARD ANSWER BACK SETTING IN WORK SUPPORT Select INTELLIGENT KEY of BCM using CONSULT. Select HAZARD ANSWER BACK in WORK SUPPORT mode. Check the HAZARD ANSWER BAC ...

Other materials:

P0982 Shift solenoid D
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0982 Shift Solenoid D Control Circuit Low The following diagnosis conditions are met, and the current monitor reading of the TCM high clutch/low & revers ...

Parking brake switch
Component Function Check 1.CHECK PARKING BRAKE SWITCH OPERATION Check that brake warning lamp in combination meter turns ON/OFF when parking brake is actuated. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis procedure. Refer to BRC "Diagno ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0087