Nissan Versa (N17): Vehicle speed sensing auto lock operation does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Vehicle speed sensing auto lock operation does not operate

Diagnosis Procedure

1.CHECK AUTOMATIC LOCK/UNLOCK SELECT SETTING IN WORK SUPPORT

  1. Select DOOR LOCK of BCM using CONSULT.
  2. Select AUTOMATIC LOCK/UNLOCK SELECT in WORK SUPPORT mode.
  3. Check AUTOMATIC LOCK/UNLOCK SELECT setting in WORK SUPPORT.

    Refer to BCS "DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)".

Is the inspection result normal?

YES >> GO TO 2.

NO >> Set Lock Only or Lock/Unlock in WORK SUPPORT.

2.CHECK AUTOMATIC DOOR LOCK SELECT SETTING IN WORK SUPPORT

  1. Select DOOR LOCK of BCM using CONSULT.
  2. Select AUTOMATIC DOOR LOCK SELECT in WORK SUPPORT mode.
  3. Check AUTOMATIC DOOR LOCK SELECT setting in WORK SUPPORT.

    Refer to BCS "DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Set VH SPD in AUTOMATIC DOOR LOCK SELECT.

3.REPLACE BCM

  1. Replace BCM. Refer to BCS "Removal and Installation".
  2. Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Auto door lock operation does not operate

Diagnosis Procedure 1.CHECK AUTO LOCK SET SETTING IN WORK SUPPORT Select INTELLIGENT KEY of BCM using CONSULT. Select AUTO LOCK SET in WORK SUPPORT mode. Check AUTO LOCK SET setting in WORK ...

IGN OFF Interlock door unlock function does not operate

Diagnosis Procedure 1.CHECK AUTOMATIC LOCK/UNLOCK SELECT SETTING IN WORK SUPPORT Select DOOR LOCK of BCM using CONSULT. Select AUTOMATIC LOCK/UNLOCK SELECT in WORK SUPPORT mode. Check AUTOM ...

Other materials:

Pedal vibration or ABS operation sound occurs
Diagnosis Procedure CAUTION: Under the following conditions, ABS is activated and vibration is felt when brake pedal is lightly depressed (just place a foot on it). However, this is normal. When shifting gears When driving on slippery road During cornering at high speed When passing o ...

Glove box assembly and housing
Removal and Installation REMOVAL     1.   Remove glove box lid. a. Open glove box lid. b. Pull glove box lid rearward and glove box lid hinges down and rearward to disengage, then remove the glove box lid. c. Disconnect glove box damper (if equipped).    ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007