Nissan Versa (N17): Key reminder function does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Key reminder function does not operate

Diagnosis Procedure

1.CHECK ANTI KEY LOCK IN FUNCTI SETTING IN WORK SUPPORT

  1. Select INTELLIGENT KEY of BCM using CONSULT.
  2. Select ANTI KEY LOCK IN FUNCTI in WORK SUPPORT mode.
  3. Check ANTI KEY LOCK IN FUNCTI setting in WORK SUPPORT.

    Refer to BCS "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)".

Is the inspection result normal?

YES >> GO TO 2.

NO >> Set On in ANTI KEY LOCK IN FUNCTI.

2.CHECK DOOR SWITCH

Check door switch.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

  • Instrument center: Refer to DLK "DTC Logic".
  • Console: Refer to DLK "DTC Logic".
  • Trunk room: Refer to DLK "DTC Logic".

Is the inspection result normal?

YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK UNLOCK SENSOR

Check unlock sensor.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.REPLACE BCM

  1. Replace BCM. Refer to BCS "Removal and Installation".
  2. Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Hazard and buzzer reminder does not operate

Diagnosis Procedure 1.CHECK HAZARD ANSWER BACK SETTING IN WORK SUPPORT Select INTELLIGENT KEY of BCM using CONSULT. Select HAZARD ANSWER BACK in WORK SUPPORT mode. Check the HAZARD ANSWER BAC ...

OFF Position warning does not operate

Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC ind ...

Other materials:

Control linkage
Exploded View 1. Shifter lever A 2. Selector lever 3. Selector cable 4. Shifter cable 5. Cable mounting bracket 6. Tapping bolt 7. Bracket 8. Grommet 9. M/T shift selector assembly 10. Shift selector 11. Shift selector handle Removal and Installation REMOVAL Move the shift selector to ...

Transaxle
Transaxle : cross-sectional view 1. Converter housing 2. Oil pump 3. Low clutch 4. Rear planetary gear 5. Low & reverse brake 6. Front planetary gear 7. Low one-way clutch 8. High clutch 9. Reverse clutch 10. 2-4 brake band (Brake band) 11. Band servo piston 12. Side cover 13. Output ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007