The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Manual.
WARNING:
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
Precautions for Trouble Diagnosis
CAUTION: Follow the instructions listed below. Failure to do this may cause damage to parts:
NOTE: A fray of twisted lines must be within 110 mm (4.33 in).
NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
1. Combination meter
- M82: TYPE A
- M24: TYPE B
2. AV control unit M70
3. ABS actuator and electric unit (control unit) E33
4. TCM
- F44: CVT models
- F57: A/T models
5. ECM E16
6. IPDM E/R E46
7. EPS control unit M53
8. BCM
- M97: Models with Intelligent Key system
- M18: Models without Intelligent Key system
9. Data link connector M22
10. Steering angle sensor M64
11. Air bag diagnosis sensor unit M35
SYSTEM
Trouble Diagnosis Flow Chart Trouble Diagnosis Procedure INTERVIEW WITH CUSTOMER Interview with the customer is important to detect the root cause of CAN communication system errors and t ...
Cylinder block
Exploded View
1. Crankshaft position sensor cover 2. Crankshaft position sensor (POS) 3.
Oring
4. Drain plug 5. Cylinder block 6. Oil level gauge
7. Oil level gauge guide 8. Oring 9. Knock sensor 10. Oil temperature sensor
11. Oil pressure sensor 12. Oil jet
13. Top ring 14. Second ring ...
Front suspension member
Exploded View
1. Front suspension member 2. Transverse link
Removal and Installation
REMOVAL
Remove the wheel and tire assemblies using power tool. Refer to WT
"Adjustment".
Remove transverse link. Refer to FSU-12, "Removal and Installation".
Remove steering o ...