CAN FUNDAMENTAL
HOW TO USE THIS MANUAL
HOW TO USE THIS SECTION
Information
Body control system (BCS)WITH INTELLIGENT KEY SYSTEM ...

IPDM E/R (WITH I-KEY) ...
Engine stand setting
Setting
NOTE:
The following procedures explain how to disassemble the engine with the engine
stand fastened to the bell
housing. Some steps may be different if using a different type of engine stand.
1. Install engine to engine stand:
a. Rem ...
C1145, C1146 Yaw rate/side/decel g
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
Turn ignition switch OFF to ON.
Perform self diagnostic result.
Is DTC C1145 or C1146 detected?
YES >> Proceed to diagnosis procedure. Refer to BRC "Diagn ...