Nissan Versa (N17): M&A Branch line circuit

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / LAN System (LAN) / M&A Branch line circuit

Diagnosis Procedure

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of combination meter.

2. Check the resistance between the combination meter harness connector terminals.

NOTE: Check the vehicle type confirm the service information. Refer to MWI "Information".

- Models with Type A

- Models with Type B

Is the measurement value within the specification?

YES >> GO TO 3.

NO >> Repair the combination meter branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the combination meter. Refer to the following.

  • TYPE A: MWI "COMBINATION METER : Diagnosis Procedure"
  • TYPE B: MWI"COMBINATION METER : Diagnosis Procedure"

Is the inspection result normal?

YES (Present error)>>Replace the combination meter. Refer to the following.

  • TYPE A: MWI "Removal and Installation"
  • TYPE B: MWI "Removal and Installation"

YES (Past error)>>Error was detected in the combination meter branch line.

NO >> Repair the power supply and the ground circuit.

EPS Branch line circuit

Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the EPS control unit f ...

STRG Branch line circuit

Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the steering angle senso ...

Other materials:

Positive crankcase ventilation
Inspection 1.CHECK PCV VALVE With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes through it. A strong vacuum should be felt immediately when a finger is placed over valve inlet. Is the inspection result normal? YES &g ...

Component parts
Component Parts Location 1 BCM (view with instrument panel removed) 2 Remote keyless entry receiver (view with instrument panel removed) 3 Transmitter 4 Combination meter (with type A) 5 Combination meter (with type B) Component Description Component parts Function ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.011