Nissan Versa (N17): Push-button ignition switch

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / Power control system (PCS) / Push-button ignition switch

Removal and Installation

REMOVAL

1. Remove NATS antenna amp. Refer to SEC "Removal and Installation".

2. Release the push-button ignition switch pawls and remove the push-button ignition switch (1).

Pawl

REMOVAL

INSTALLATION

Install in the reverse order of removal.

Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", us ...

Other materials:

Additional service when replacing transaxle assembly
Description Perform the following work after the transaxle assembly is replaced. ERASING AND LOADING OF THE CALIBRATION DATA The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM ...

Shift control
SHIFT CONTROL : System Description SYSTEM DIAGRAM DESCRIPTION To select the gear ratio that can give the driving force to meet driver's intent or vehicle situation, the vehicle driving condition such as vehicle speed or accelerator pedal position is detected and the most appropriate g ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0152