Nissan Versa (N17): Push-button ignition switch does not operate

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / Power control system (PCS) / Push-button ignition switch does not operate

Description

Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.

NOTE: The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.

Conditions of Vehicle (Operating Conditions)

  • "ENGINE START BY I-KEY" in "WORK SUPPORT" is ON when setting on CONSULT.
  • One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.

Diagnosis Procedure

1.PERFORM WORK SUPPORT

Perform "INSIDE ANT DIAGNOSIS" on Work Support of "INTELLIGENT KEY".

Refer to BCS "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)".

>> GO TO 2.

2.PERFORM SELF-DIAGNOSIS RESULT

Perform Self-Diagnosis Result of "BCM".

Is DTC detected?

YES >> Refer to BCS "DTC Index".

NO >> GO TO 3.

3.CHECK PUSH-BUTTON IGNITION SWITCH

Check push-button ignition switch.

Refer to PCS "Component Function Check".

Is the operation normal?

YES >> GO TO 4.

NO >> Repair or replace malfunctioning parts.

4.CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> GO TO 1.

REMOVAL AND INSTALLATION

BCM (BODY CONTROL MODULE)

Removal and Installation

For removal and installation of the BCM (Body Control Module), refer to BCS "Removal and Installation" (WITH INTELLIGENT KEY SYSTEM) or BCS "Removal and Installation" (WITHOUT INTELLIGENT KEY SYSTEM).

Push-button ignition switch

Removal and Installation REMOVAL 1. Remove NATS antenna amp. Refer to SEC "Removal and Installation". 2. Release the push-button ignition switch pawls and remove the push-button igniti ...

Other materials:

Rear window defroster switch
To defrost the rear window glass, start the engine and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to turn the defroster off. The rear window defroster automatically turns off after approximately 15 m ...

Sun visors
1. To block glare from the front, swing down the sun visor 1 . 2. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side 2 . 3. Slide the extension 3 sun visor in or out as needed. CAUTION Do not store the sun visor before returning ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007