Exploded View
1. Lower joint 2. Intermediate shaft 3. Steering column assembly
REMOVAL
CAUTION: Spiral cable may be cut if steering wheel turns while separating steering column assembly and steering gear assembly. Be sure to secure steering wheel using string to avoid turning.
CAUTION:
Replace the lower joint with a new one if damaged.
CAUTION:
INSTALLATION
CAUTION: Spiral cable may be cut if steering wheel turns while separating steering column assembly and steering gear assembly. Be sure to secure steering wheel using string to avoid turning.
Installation is in the reverse order of removal.
CAUTION: If a guide protrusion is not included, align with the matching mark placed at the removal step.
INSPECTION AFTER REMOVAL
INSPECTION AFTER INSTALLATION
- Steering wheel play: Refer to ST "Inspection".
- Neutral position steering wheel, steering wheel turning force, and front wheel turning angle: Refer to ST "Inspection".
Exploded View 1. Steering column assembly 2. Clamp ...
Exploded View 1. Guide 2. Cowl seal 3. Steering gear assembly 4. Front suspension member Front Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc., cap o ...
Security systems (if so equipped)
Your vehicle has one type of security systems:
NISSAN Vehicle Immobilizer System
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
If the engine fails to start using a registered key
(for ex ...
Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the VDC system
on for most driving conditions.
If the vehicle is stuck in mud or snow, the VDC
system reduces the engine output to reduce
wheel spin. The engine speed will be reduced
even if the accelerator is depressed to the floor. If
maximum engine po ...