Removal and Installation
REMOVAL
1. Remove the headlining assembly. Refer to INT "Removal and Installation".
2. Disconnect the satellite radio antenna retainers (A) using a suitable tool.
3. Disconnect the harness connectors (B) from satellite radio antenna.
4. Remove the satellite radio antenna nut (1).
5. Remove the satellite radio antenna.

INSTALLATION
Installation is in the reverse order of removal.
Rear door speakerRemoval and Installation REMOVAL 1. Remove the rear door finisher. Refer to INT "Removal and Installation". 2. Remove the rear door speaker screws (A). 3. Disconnect the harness connec ...

Removal and Installation 1. Steering wheel 2. Steering wheel audio control switches 3. Driver air bag module 4. Steering wheel rear finisher REMOVAL 1. Remove the steering wheel. Refer to ST ...
Push-button ignition switch (if so equipped)
WARNING
Do not operate the push-button ignition
switch while driving the vehicle except in
an emergency. (The engine will stop when
the ignition switch is pushed 3 consecutive
times in quick succession or the ignition
switch is pushed and held for more
than 2 seconds.) If the engine stops ...
Trunk rear plate
TRUNK REAR PLATE : Removal and Installation
REMOVAL
Fully open trunk lid.
Remove trunk floor carpet.
Remove trunk rear plate clips (A).
4. Release trunk rear plate pawls using a
suitable tool (A) and
remove trunk rear plate as shown.
INSTALLATION
...