Removal and Installation

1. Steering wheel 2. Steering wheel audio control switches 3. Driver air bag module 4. Steering wheel rear finisher
REMOVAL
1. Remove the steering wheel. Refer to ST "Removal and Installation".
2. Remove the steering wheel rear finisher.
3. Remove the steering wheel audio control switches screws.
4. Remove the steering wheel audio control switches from the steering wheel.
INSTALLATION
Installation is in the reverse order of removal.
Roof antennaExploded View 1. Antenna mast 2. Antenna base Removal and Installation REMOVAL 1. Remove the headlining. Refer to INT "Removal and Installation". 2. Disconnect the antenna cable. 3 ...

Removal and Installation REMOVAL 1. Remove the rear seat cushion assembly. Refer to SE "Removal and Installation - Seat Cushion Assembly". 2. Remove the rear step plate (RH). 3. Rem ...
Intake valve timing control
Intake valve timing control : System Diagram
Intake valve timing control : system description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*1
Piston position
Intake valve timing
con ...
C1145, C1146 Yaw rate/side/decel g
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
Turn ignition switch OFF to ON.
Perform self diagnostic result.
Is DTC C1145 or C1146 detected?
YES >> Proceed to diagnosis procedure. Refer to BRC "Diagn ...