Nissan Versa (N17): Torsion bar

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Torsion bar

TORSION BAR : Removal and Installation

REMOVAL

Remove torsion bar clamp.
Support trunk lid with a suitable tool.

WARNING: Bodily injury may occur if trunk lid is not supported properly when removing the torsion bars.

REMOVAL

3. Apply a torsion bar wrench (A) to torsion bar (1) and lift torsion bar to remove it.

NOTE: For torsion bar wrench, refer to the figure.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Check trunk lid open/close operation after installation.

Trunk lid hinge

TRUNK LID HINGE : Removal and Installation REMOVAL 1. Remove harness clips (A) from trunk lid hinge (RH only) (1). 2. Remove trunk lid assembly. Refer to DLK "TRUNK LID ASSEMBLY : Removal ...

Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation REMOVAL Remove trunk lid weatherstrip from the trunk lid opening. CAUTION: Do not pull excessively on weatherstrip. INSTALLATION 1. Working fro ...

Other materials:

Cooling fan control
Cooling fan control : system diagram Cooling fan control : system description INPUT/OUTPUT SIGNAL CHART Sensor Input signal to ECM ECM function Actuator Crankshaft position sensor (POS) Camshaft position sensor (PHASE) Engine speed*1 Piston position Cool ...

Headlamp (LO) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM via the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 40 and 41, located in the IPDM E/R. (Without dayti ...

Nissan Versa (N17): Torsion bar

Trunk lid hinge

Trunk lid weather-strip

Other materials:

Categories