Nissan Versa (N17): Trunk lid weather-strip

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation

REMOVAL

Remove trunk lid weatherstrip from the trunk lid opening.

CAUTION: Do not pull excessively on weatherstrip.

INSTALLATION

1. Working from the upper section, align weatherstrip center mark (A) with vehicle center mark (B) and install weatherstrip onto the vehicle.

: Front

REMOVAL

2. Align the connecting point (B) of weatherstrip (2) to the center (A) of striker (1) and install as shown.

REMOVAL

3. Make sure entire weatherstrip is firmly seated.

NOTE: Check that weatherstrip fits tightly all around the opening, especially in each corner and along the luggage rear plate.

HOOD LOCK

Exploded View

Exploded View

1. Secondary latch 2. Hood lock assembly 3. Hood lock control cable assembly Clip

Torsion bar

TORSION BAR : Removal and Installation REMOVAL Remove torsion bar clamp. Support trunk lid with a suitable tool. WARNING: Bodily injury may occur if trunk lid is not supported properly when ...

Hood lock

HOOD LOCK : Removal and Installation REMOVAL Remove hood lock assembly bolts and hood lock assembly. Disconnect hood lock control cable assembly (2) from hood lock assembly (1). INSTALLA ...

Other materials:

A/T Shift lock system
A/T Shift lock system : component parts location 1 Stop lamp switch. 2 Shift lock release lever. 3 Park position switch. 4 Shift lock solenoid. A/T Shift lock system : component description ...

Front drive shaft
Exploded View 1. Drive shaft 2. Cotter pin A. Apply Molykote M77 Removal and Installation REMOVAL Remove the wheel and tire assembly using power tool. Refer to WT "Adjustment". Remove wheel sensor and sensor harness. Refer to BRC "FRONT WHEEL SENSOR : Removal and ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0072