Nissan Versa (N17): Hood lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Hood lock

HOOD LOCK : Removal and Installation

REMOVAL

  1. Remove hood lock assembly bolts and hood lock assembly.
  2. Disconnect hood lock control cable assembly (2) from hood lock assembly (1).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Be careful not to bend the cable too much, keep the radius 100 mm (3.94 in) or more.
  • After installation, check that hood lock control cable is properly engaged with hood lock.
  • After installation, perform hood adjustment procedure. Refer to DLK "HOOD ASSEMBLY : Adjustment".
  • After adjusting, perform hood lock control inspection. Refer to DLK "Inspection".

Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation REMOVAL Remove trunk lid weatherstrip from the trunk lid opening. CAUTION: Do not pull excessively on weatherstrip. INSTALLATION 1. Working fro ...

Hood lock control cable

HOOD LOCK CONTROL CABLE : Removal and Installation REMOVAL Disconnect hood lock control cable assembly from hood lock assembly. Refer to DLK "HOOD LOCK : Removal and Installation&quo ...

Other materials:

Towing your vehicle
When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are generally familiar with the applicable laws an ...

P1715 Input speed sensor
Description ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P1715 is displa ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.017