Nissan Versa (N17): Trunk lid striker

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid striker

TRUNK LID STRIKER : Removal and Installation

REMOVAL

1. Remove trunk rear plate. Refer to INT "TRUNK REAR PLATE : Removal and Installation".

2. Remove trunk lid opener cable bolt (A) and trunk lid striker bolts (B).

REMOVAL

3. Remove trunk lid striker (1), disconnect trunk lid opener cable (2) from trunk lid striker and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

After installation, check trunk lid open/close, lock/unlock operation.
After installation, perform the trunk lid adjustment procedure. Refer to DLK "TRUNK LID ASSEMBLY : Adjustment".

Trunk lid hinge

TRUNK LID HINGE : Removal and Installation REMOVAL 1. Remove harness clips (A) from trunk lid hinge (RH only) (1). 2. Remove trunk lid assembly. Refer to DLK "TRUNK LID ASSEMBLY : Removal ...

Other materials:

Vehicle jerks during VDC/TCS/ABS control
Diagnosis Procedure 1.SYMPTOM CHECK Check if the vehicle jerks during VDC/TCS/ABS control. Is the inspection result normal? YES >> Inspection End. NO >> GO TO 2 2.CHECK SELF DIAGNOSTIC RESULT Perform self diagnostic result of ABS actuator and electric unit (control unit). Refe ...

Trunk lid opener handle
TRUNK LID OPENER HANDLE : Removal and Installation REMOVAL 1. Remove front kicking plate (LH). Refer to INT "KICKING PLATE INNER : Removal and Installation". 2. Disengage pawl using a suitable tool (A) and open the harness clip. : Pawl 3. Position floor carpet aside as necessary ...

Nissan Versa (N17): Trunk lid striker

Trunk lid assembly

Trunk lid hinge

Other materials:

Categories