DTC Logic
DTC DETECTION LOGIC 
Diagnosis Procedure
1.CHECK DTC DETECTION
With CONSULT.
1. Turn ignition switch OFF to ON.
2. Perform self diagnostic result.
Is DTC U1000 detected?
YES >> Proceed to diagnosis procedure. Refer to LAN "Trouble Diagnosis Flow Chart".
NO >> Refer to GI "Intermittent Incident".
U1010 CONTROL UNIT (CAN)
Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC 
Diagnosis Procedure
1.REPLACE COMBINATION METER
Replace combination meter. Refer to MWI "Removal and Installation".
>> Inspection End.
Diagnosis and repair workflowWork Flow OVERALL SEQUENCE DETAILED FLOW 1.CONFIRM SYMPTOM Confirm symptom or customer complaint. >> GO TO 2 2.SELF-DIAGNOSIS OF COMBINATION METER Perform self-diagnosis of combinat ...

Description The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines. DTC Logic ...
Vehicle jerks during VDC/TCS/ABS
control
Diagnosis Procedure
1.SYMPTOM CHECK
Check if the vehicle jerks during VDC/TCS/ABS control.
Is the inspection result normal?
YES >> Inspection End.
NO >> GO TO 2
2.CHECK SELF DIAGNOSTIC RESULT
Perform self diagnostic result of ABS actuator and electric unit (control
unit). Refe ...
Filament
Inspection and Repair
INSPECTION
1. When measuring voltage, wrap tin foil around the top of the negative
probe. Then press the foil against the wire with your finger.
2. Attach probe circuit tester (in Volt range) to middle portion of
each filament.
3. If a filament is burned out, circui ...