DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK CHARGING SYSTEM
Check the vehicle charging system. Refer to CHG "Work Flow (With EXP-800 NI or GR8-1200 NI)" or CHG-16, "Work Flow (Without EXP-800 NI or GR8-1200 NI)".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning components.
2.CHECK AV CONTROL UNIT POWER SUPPLY AND GROUND CIRCUITS
Perform the AV control unit power supply and ground circuit diagnosis procedure. Refer to AV "AV CONTROL UNIT : Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace the AV control unit. Refer to AV "Removal and Installation".
NO >> Repair or replace harness or connectors.
U12AA Configuration errorDTC Logic DTC DETECTION LOGIC CONSULT Display DTC Detection Condition Possible Cause Configuration Error [U12AA] AV control unit is not properly configured or configurati ...

DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK CHARGING SYSTEM Check the vehicle charging system. Refer to CHG "Work Flow (With EXP-800 NI or GR8-1200 NI)" or CHG "W ...
Service data and specifications
(SDS)
Periodical Maintenance Specification
ENGINE OIL CAPACITY (APPROXIMATE)
  ...
Low tire pressure warning lamp
blinks
Diagnosis Procedure
NOTE:
If low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for
0.2 seconds, wake-up operation
for all transmitters is not complete.
Carry out transmitter wake-up operation. Refer to WT "Work Procedure".
1.CHECK BCM CONNECTOR
Turn igniti ...