DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK CHARGING SYSTEM
Check the vehicle charging system. Refer to CHG "Work Flow (With EXP-800 NI or GR8-1200 NI)" or CHG "Work Flow (Without EXP-800 NI or GR8-1200 NI)".
Is the inspection result normal?
YES >> Replace the AV control unit. Refer to AV "Removal and Installation".
NO >> Repair or replace the malfunctioning components.
U1310 AV CONTROL UNIT
DTC Logic
| CONSULT Display | DTC Detection Condition | Possible Cause |
| CONTROL UNIT (AV) [U1310] | Error during CAN controller hardware initialization (MCAN). | Replace AV control unit if malfunction occurs
constantly.
Refer to AV "Removal and Installation". |
U12B0 Power supply voltageDTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK CHARGING SYSTEM Check the vehicle charging system. Refer to CHG "Work Flow (With EXP-800 NI or GR8-1200 NI)" or CHG-16, " ...

AV CONTROL UNIT AV CONTROL UNIT : Diagnosis Procedure Regarding Wiring Diagram information, refer to AV "Wiring Diagram". 1.CHECK FUSE Check that the following fuses are not blown. Are ...
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the tire sidewall between tread shoulder and
maximum section width. For example:
Treadwear 200 ...
Clutch piping
Exploded View
1. CSC (Concentric Slave Cylinder) 2. Clutch tube 3. Clutch damper
4. Bracket 5. Master cylinder
Hydraulic Layout
1. Clutch tube 2. Lock pin 3. CSC (concentric slave cylinder)
4. Clutch damper 5. Master cylinder 6. Clutch pedal
Removal and Installation
CAUTION:
Do not ...