Nissan Versa (N17): Washer nozzle

Washer nozzle  : Removal and Installation

REMOVAL

1. Remove cowl top cover. Refer to EXT "Removal and Installation".

2. Disconnect washer tube from washer nozzle (1).

3. Place cowl top cover (2) up side down, then release washer nozzle pawl to remove as shown.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • The spray positions differ, check that left and right nozzles are installed correctly.
  • Adjust the nozzle spray pattern. Refer to WW "WASHER NOZZLE : Inspection and Adjustment".

Washer nozzle : Inspection and Adjustment

INSPECTION

Check valve Inspection

Check that air can pass through the nozzle by blowing into the nozzle and that air cannot flow in the opposite direction.

INSPECTION

ADJUSTMENT

Washer Nozzle Spray Position Adjustment

Adjust spray positions to match the positions shown.

ADJUSTMENT

1. Black printed frame line

: Spray area

ADJUSTMENT

1. If washer nozzle (1) spray pattern is not within specification adjust using suitable tool (A).

CAUTION: Do not use needle or small pin to adjust the washer nozzle.

NOTE:

  • Washer nozzle adjuster is included with shipment of washer nozzle.
  • If wax or dust gets into the nozzle, remove wax or dust with a needle or small pin.

ADJUSTMENT

Washer pump

Exploded View 1. Washer tank 2. Front washer tube 3. Washer pump 4. Seal Front Removal and Installation REMOVAL 1. Remove fender protector. Refer to EXT "Removal and Installation" ...

Washer tube

WASHER TUBE : Removal and Installation REMOVAL 1. Remove front washer tube from the washer pump. Refer to WW "Removal and Installation". 2. Remove front washer tube from the front washe ...

Other materials:

Fuel-filler door
Opener operation The fuel-filler door release is located below the instrument panel. To open the fuel-filler door, pull the release. To lock, close the fuel-filler door securely. Fuel-filler cap WARNING Gasoline is extremely flammable and highly explosive under certain conditions. ...

Mainshaft and gear
Exploded View 1. Mainshaft front bearing 2. Mainshaft 3. 1st main gear 4. 1st inner baulk ring 5. 1st synchronizer cone 6. 1st outer baulk ring 7. 1st-2nd synchronizer hub 8. 1st-2nd coupling sleeve 9. Spring 10. Insert key 11. 2nd outer baulk ring 12. 2nd synchronizer cone 13. 2nd inner b ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0055