WASHER TUBE : Removal and Installation
REMOVAL
1. Remove front washer tube from the washer pump. Refer to WW "Removal and Installation".
2. Remove front washer tube from the front washer nozzle. Refer to WW "WASHER NOZZLE : Removal and Installation".
3. Remove front washer tube clip.
4. Remove front washer tube from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
WIPER AND WASHER SWITCH
Removal and Installation
The wiper and washer switch is serviced as an assembly with the combination switch. Refer to EXL "Removal and Installation".
SERVICE DATA AND SPECIFICATIONS (SDS)
Specifications
WINDSHIELD WASHER FLUID
Windshield washer fluid capacity | 3.5 (3 3/4 US qt, 3 1/8 Imp qt) |
Windshield washer fluid specification | Refer to MA "Fluids and Lubricants". |
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", us ...
Exhaust manifold
Exploded View
1. Exhaust manifold cover 2. Harness bracket 3. Airfuel ratio sensor 1 4.
Exhaust manifold stay 5. Heat insulator 6. Exhaust manifold 7. Exhaust manifold
cover 8. Gasket
: Engine front
Removal and Installation
REMOVAL
Remove air duct (inlet), air duct and air cleaner as ...
Low tire pressure warning lamp
blinks
Diagnosis Procedure
NOTE:
If low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for
0.2 seconds, wake-up operation
for all transmitters is not complete.
Carry out transmitter wake-up operation. Refer to WT "Work Procedure".
1.CHECK BCM CONNECTOR
Turn igniti ...