ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
Always perform zero point reset using CONSULT when removing and installing the passenger seat or servicing the occupant classification system.
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement
WORK PROCEDURE WHEN REPLACING OCS CONTROL UNIT
1.PERFORM ZERO POINT RESET
Perform zero point reset. Refer to SRC "ZERO POINT RESET : Special Repair Requirement".
>> END
ZERO POINT RESET : Description
Zero point reset is an initializing procedure for the OCS (weight) sensors that must be performed using CONSULT when removing and installing passenger seat or servicing the OCS system. If zero point reset is not performed, the initialization is incomplete and OCS may not operate normally.
NOTE:
ZERO POINT RESET : Special Repair Requirement
1.PERFORM ZERO POINT RESET
1. Perform preliminary checks:
NOTE:
>> GO TO 2.
2.CONFIRM RESET
1. Check that ""Complete" is displayed on "Zero point reset status".
CAUTION:
Is zero point reset status "complete"?
YES >> Print out "ZERO POINT RESET CURRENT STATUS" screen. Inspection end.
NO >> Recheck the preliminary check items and perform zero point reset again.
INTERMITTENT INCIDENT
Inspection Procedure
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being detected currently. This DTC will not be detected on SELF-DIAG [CURRENT], but may be viewed on SELF-DIAG [PAST] if the DTC has not been erased.
Trouble Diagnosis with CONSULT
CHECK SRS REPAIR HISTORY
Refer to SRC "SRS History Check".
DTC/CIRCUIT DIAGNOSIS
Work Flow OVERALL SEQUENCE *1 SRC "Diagnosis Description" *2 SRC "SRS Operation Check" *3 SRC "Trouble Diagnosis with CONSULT" *4 SRC "Trouble Diagnosis wi ...
Description DTC B1049 - B1052, B1054 - B1057 DRIVER AIRBAG MODULE The driver air bag module is dual stage and wired to the air bag diagnosis sensor unit through the spiral cable. The air bag d ...
Multiport fuel injection system
MULTIPORT FUEL INJECTION SYSTEM : System Diagram
MULTIPORT FUEL INJECTION SYSTEM : System
Description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*4
Piston position
Fuel injection & ...
Insufficient heating
Description
Symptom
Insufficient heating
No warm air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnosis with CONSULT before performing symptom diagnosis. If any
malfunction result or DTC
is detected, perform the corresponding diagnosis.
1.CHECK ...