Nissan Versa (N17): Brake drum

Nissan Versa 2nd generation (N17) Service Manual / Brakes / Brake system (BR) / Brake drum

BRAKE DRUM : Inspection and Adjustment

INSPECTION

Appearance

Check surface of brake drum for uneven wear, cracks and serious damage. Replace it if necessary. Refer to BR "Removal and Installation".

Brake Drum Inner Diameter

Check inner diameter (B) of the brake drum.

(B) : Refer to BR "Rear Drum Brake".

Brake Drum Inner Diameter

ADJUSTMENT

Burnish contact surfaces between brake drum and brake lining according to the following procedure after refinishing or replacing brake drum, or if a soft pedal occurs at very low mileage.

CAUTION:

  • Be careful of vehicle speed because the brake does not operate firmly/securely until brake drum and brake lining are securely fitted.
  • Only perform this procedure under safe road and traffic conditions. Use extreme caution.
  1. Drive vehicle on straight, flat road.
  2. Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops.
  3. Drive without depressing brake for a few minutes to cool the brake.
  4. Repeat steps 1 to 3 until brake drum and brake lining are securely fitted.

REMOVAL AND INSTALLATION

Brake lining

BRAKE LINING : Inspection and Adjustment INSPECTION Brake Lining Remove plug from back plate. Refer to BR "Exploded View". Check brake lining wear thickness (A) from an inspection ho ...

Brake pedal

Exploded View 1. Clevis pin 2. Brake pedal assembly 3. Brake pedal pad 4. Stop lamp switch 5. Clip 6. Snap pin 7. ASCD cancel switch (if equipped) NOTE: CVT and A/T brake pedal assemblies sh ...

Other materials:

Low tire pressure warning lamp does not turn off
Diagnosis Procedure 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace damaged parts. 2.BCM POWER SUPPLY AND GROUND CIRCUITS ...

Adjustment of steering angle sensor neutral position
Description Refer to the table below to determine if adjustment of steering angle sensor neutral position is required. Work Procedure ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION CAUTION: To adjust neutral position of steering angle sensor, make sure to use CONSULT. (Adjustme ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0075