Nissan Versa (N17): B2628 Outside antenna

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / B2628 Outside antenna

DTC Logic

DTC DETECTION LOGIC 

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Check Self Diagnostic Result mode of BCM using CONSULT.

Is outside key antenna DTC detected?

YES >> Refer to DLK "Diagnosis Procedure".

NO >> Outside key antenna (rear bumper) is OK.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".

1.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

  1. Turn ignition switch ON.
  2. Check signal between BCM harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> GO TO 2.

2.CHECK OUTSIDE KEY ANTENNA CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect BCM connector and outside key antenna (rear bumper) connector.
  3. Check continuity between BCM harness connector and outside key antenna (rear bumper) harness connector.             
  4. Check continuity between BCM harness connector and ground.   

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness.

3.CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

  1. Replace outside key antenna (rear bumper). (New antenna or other antenna)
  2. Connect BCM and outside key antenna (rear bumper) connector.
  3. Turn ignition switch ON.
  4. Check signal between BCM harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> Replace outside key antenna (rear bumper).

NO >> Replace BCM. Refer to BCS "Removal and Installation".

Power supply and ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown.&nb ...

Other materials:

U0155 Lost communication (IPC)
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0155 Lost Communication With Instrument Panel Cluster (IPC) Control Module When the ignition switch is ON, TCM is unable to receive the CAN communications ...

Tire pressure monitoring system
TIRE PRESSURE MONITORING SYSTEM : System Diagram TIRE PRESSURE MONITORING SYSTEM : System Description The BCM has pressure judgment and trouble diagnosis functions. When the BCM detects low inflation pressure or another unusual symptom, the low tire pressure warning lamp in the c ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0074