Nissan Versa (N17): Door mirror glass

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Mirrors (MIR) / Door mirror glass

Removal and Installation

REMOVAL

1. Place a piece of protective tape on the mirror housing.

2. Tilt the door mirror glass upward (1).

3. Remove the door mirror glass lower side, using a suitable tool (A) in the recess between door mirror glass (1) and actuator (2) and push up on pawls and rotate (twist).

REMOVAL

4. Disconnect harness connector from door mirror glass (if equipped with heated mirrors).

5. Remove the glass using a suitable tool in the (LH/RH) recesses between door mirror glass and actuator and push up on pawls and rotate (twist).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

NOTE: After installation, visually check that pawls are securely engaged.

Front door corner finisher

FRONT DOOR CORNER FINISHER : Removal and Installation REMOVAL 1. Apply protective tape (A) on the door panel. Disengage the pawls and remove front door corner finisher using a suitable tool (B) ...

Door mirror rear finisher

Removal and Installation REMOVAL 1. Remove the door mirror glass. Refer to MIR "Removal and Installation". 2. Apply protective tape on mirror body (A). Disengage the pawls and remove d ...

Other materials:

Before starting the engine
Make sure the area around the vehicle is clear. Check fluid levels such as engine oil, coolant, brake and clutch fluid (if so equipped), and windshield-washer fluid as frequently as possible, or at least whenever you refuel. Check that all windows and lights are clean. Visually insp ...

PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0099