Nissan Versa (N17): Front door corner finisher

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Mirrors (MIR) / Front door corner finisher

FRONT DOOR CORNER FINISHER : Removal and Installation

REMOVAL

1. Apply protective tape (A) on the door panel. Disengage the pawls and remove front door corner finisher using a suitable tool (B).

: Pawl

REMOVAL

INSTALLATION

Installation is in the reverse order or removal.

  • Inspect front door corner finisher pawls for damage, install new pawls (if necessary).
  • Align front door corner finisher to pawls and press pawls in securely.

Door mirror assembly

DOOR MIRROR ASSEMBLY : Removal and Installation REMOVAL CAUTION: Use the following steps to disengage the door mirror corner cover from the mirror assembly. Other methods to remove the door mirr ...

Door mirror glass

Removal and Installation REMOVAL 1. Place a piece of protective tape on the mirror housing. 2. Tilt the door mirror glass upward (1). 3. Remove the door mirror glass lower side, using a suitable ...

Other materials:

EVAP control system pressure sensor
Exploded View 1. EVAP control system pressure sensor 2. O-ring 3. EVAP canister Removal and Installation NOTE: The EVAP canister system pressure sensor can be removed without removing the EVAP canister. REMOVAL Remove the EVAP canister protector cover. Disconnect EVAP canister purg ...

Line pressure test
Work Procedure INSPECTION Check the engine oil level. Replenish if necessary. Refer to LU "Inspection". Check for CVT fluid leaks. Refer to TM "Inspection". Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0051