Nissan Versa (N17): Door mirror rear finisher

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Mirrors (MIR) / Door mirror rear finisher

Removal and Installation

REMOVAL

1. Remove the door mirror glass. Refer to MIR "Removal and Installation".

2. Apply protective tape on mirror body (A). Disengage the pawls and remove door mirror rear finisher (1) from the door mirror assembly using a suitable tool (B).

: Pawl

REMOVAL

Door mirror glass

Removal and Installation REMOVAL 1. Place a piece of protective tape on the mirror housing. 2. Tilt the door mirror glass upward (1). 3. Remove the door mirror glass lower side, using a suitable ...

Door mirror remote control switch

Removal and Installation REMOVAL 1. Remove the instrument lower panel LH (1). Refer to IP "Removal and Installation". 2. Remove door mirror remote control switch (1) from the instrum ...

Other materials:

Noise, vibration and harshness (NVH) troubleshooting
NVH troubleshooting Chart Locate the area where noise occurs. Confirm the type of noise. Specify the operating condition of engine. Check specified noise source If necessary, repair or replace these parts. Location of noise Type of noise Operating condition of ...

Oil filter
Removal and Installation REMOVAL Remove engine under cover. Drain engine oil. Remove oil filter using Tool (A).   : Front Tool number : KV10115801 (J38956) WARNING: Be careful not to get burned; engine and engine oil may be hot. CAUTION: When removing, prepare a shop cl ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0049