Nissan Versa (N17): B2193 Chain of ECM-IMMU

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B2193 Chain of ECM-IMMU

DTC Logic

DTC DETECTION LOGIC

NOTE:

If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".
If DTC B2193 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

Does the engine start?

YES >> Inspection End.

NO >> GO TO 2.

2.REPLACE ECM

1. Replace ECM.

Refer to EC "Removal and Installation".

2. Perform "ADDITIONAL SERVICE WHEN REPLACING ECM".

Refer to EC "Work Procedure".

>> Inspection End

Other materials:

Readiness for inspection/maintenance (I/M) test
Due to legal requirements in some states and Canadian Provinces, your vehicle may be required to be in what is called the "ready condition" for an Inspection/Maintenance (I/M) test of the emission control system. The vehicle is set to the "ready condition" when it is driven through certain d ...

Excessive ABS Function operation frequency
Diagnosis Procedure 1.CHECK START Check front and rear brake force distribution using a brake tester. Is the inspection result normal? YES >> GO TO 2 NO >> Check brake system. 2.CHECK FRONT AND REAR AXLE Make sure that there is no excessive play in the front and rear axles. Refer ...

Nissan Versa (N17): B2193 Chain of ECM-IMMU

DTC Logic

Diagnosis Procedure

B2192 ID discord, IMMU-ECM

B2195 Anti-scanning

Other materials:

Categories