Nissan Versa (N17): B26F3 Starter control relay

DTC Logic

DTC DETECTION LOGIC

NOTE:

• If DTC B26F3 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".
• If DTC B26F3 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS"DTC Logic".

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press push-button ignition switch under the following conditions to start engine.

• Selector lever: In the P position
• Brake pedal: Not depressed

2. Wait 2 seconds after engine started.

3. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC OF IPDM E/R

Check DTC in Self Diagnostic Result mode of IPDM E/R using CONSULT.

Is DTC detected?

YES >> Perform the diagnosis procedure related to the detected DTC. Refer to PCS "DTC Index".

NO >> GO TO 2.

2.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.