Nissan Versa (N17): Mirrors

Nissan Versa 2nd generation (N17) Owners Manual / Pre-driving checks and adjustments / Mirrors

Rearview mirror

Rearview mirror

The night position 1 reduces glare from the headlights of vehicles behind you at night.

Use the day position 2 when driving in daylight hours.

WARNING

Use the night position only when necessary, because it reduces rear view clarity.

Outside mirrors

WARNING

  • Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
  • Do not adjust the mirrors while driving.

    You could lose control of your vehicle and cause an accident.

Electric control type

Electric control type

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.

Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2.

Manual folding outside mirrors

Manual folding outside mirrors

Pull the outside mirror toward the door to fold it.

Sun visors

1. To block glare from the front, swing down the sun visor 1 . 2. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side 2 . 3. Slide the ext ...

Control panel buttons - color screen with Navigation System (if so equipped)

WARNING Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the driving operation. ...

Other materials:

Fuel filler lid lock
FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". 3. Release pawls (A) and remove fuel filler lid lock assembly (1) from opening. CAUTION: Be car ...

Power supply and ground circuit
Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0067