Nissan Versa (N17): Rear door speaker

Removal and Installation

REMOVAL

1. Remove the rear door finisher. Refer to INT "Removal and Installation".

2. Remove the rear door speaker screws (A).

3. Disconnect the harness connector from rear door speaker (1) and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Front door speaker

Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT "Removal and Installation". 2. Remove the front door speaker screws (A). 3. Disconnect the harness connec ...

USB Connector

Removal and Installation REMOVAL 1. Remove the center console assembly. Refer to IP "Removal and Installation". 2. Release the pawl from the back of the center console to remove the ...

Other materials:

Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine po ...

Hazard function
Component Function Check 1.CHECK FUNCTION Select INTELLIGENT KEY of BCM using CONSULT. Select FLASHER in ACTIVE TEST mode. Touch LH or RH to check that it works normally. Is the inspection result normal? YES >> Hazard warning lamp circuit is OK. NO >> Refer to DLK "D ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0151