STEERING GEAR AND LINKAGE : Inspection
STEERING GEAR

STEERING LINKAGE
Check ball joint, dust cover and other component parts for looseness, wear, damage and grease leakage.
Drum brakeDRUM BRAKE : Inspection BRAKE LINING Check the lining thickness (A). Check the lining for excessive wear, damage, and peeling. Repair or replace any components as necessary. Brake lin ...

AXLE AND SUSPENSION PARTS : Inspection Check front and rear axle and suspension parts for excessive play, cracks, wear or other damage. Shake each wheel to check for excessive play. Check whee ...
Lock-up control
Lock-up control : system diagram
Lock-up control : system description
The torque converter clutch piston in the torque converter is engaged to
eliminate torque converter slip to
increase power transmission efficiency.
The torque converter clutch control valve operation is controlle ...
C1607, C1608 EPS Control unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2 ...