
DRIVE BELT : Exploded View 1. Generator 2. Water pump 3. Crankshaft pulley 4. A/C compressor (with A/C models) Idler pulley (without A/C models) 5. Idler pulley 6. Drive belt DRIVE BELT : Ins ...
Stall test
Work Procedure
INSPECTION
Inspect the amount of engine oil. Replenish the engine oil if necessary.
Refer to LU "Inspection".
Drive for about 10 minutes to warm up the vehicle so that the A/T fluid
temperature is 50 to 80C (122 to
176F).
Inspect the amount of ATF. Replenish ...
Hazard and buzzer reminder does
not operate
Diagnosis Procedure
1.CHECK HAZARD ANSWER BACK SETTING IN WORK SUPPORT
Select INTELLIGENT KEY of BCM using CONSULT.
Select HAZARD ANSWER BACK in WORK SUPPORT mode.
Check the HAZARD ANSWER BACK setting in WORK SUPPORT.
Refer to BCS "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIG ...