Stall test
Work Procedure
INSPECTION
Check the engine oil level. Replenish if necessary.
Check for leak of the CVT fluid. Refer to TM "Inspection".
Drive for about 10 minutes to warm up the vehicle so that the CVT fluid
temperature is 50 to 80C (122 to
176F).
Be sure to apply the par ...
U1000 CAN COMM
DTC Logic
DTC DETECTION LOGIC
NOTE: U1000 can be set if a module harness was disconnected and
reconnected, perhaps during a repair. Confirm that there are actual CAN
diagnostic symptoms and a present DTC by performing the Self Diagnostic Result
procedure.   ...